In a hydrodynamic journal bearing , there is a thick film of lubricant between the journal and the bearing.
In hydrostatic lubrication, the load supporting high pressure fluid film is created by an external source like pump. The lubrication which is pressurized externally is supplied between the two surfaces. So, in hydrostatic lubrication the motion of one surface relative to other is not required.
1) In a hydrodynamic journal bearing , there is
Answer is:
a thick film of lubricant between the journal and the bearing
Explanation:
KPSC Water Resource Department Junior Engineer Mechanical Question Paper 2017 with Answer Key
For more MCQ's Click HereRelated KPSC Water Resource Department Junior Engineer Mechanical Question Paper 2017 with Answer Key
Answer is:
the shaft tends to vibrate vigorously in transverse direction
Explanation:
Whirling speed is also called as Critical speed of a shaft. It is defined as the speed at which a rotating shaft will tend to vibrate violently in the transverse direction if the shaft rotates in horizontal direction. In other words, the whirling or critical speed is the speed at which resonance occurs.
Answer is:
Tearing strength of punched plate/ tearing strength of the solid plate
Explanation:
Tearing efficiency of a riveted joint is the ratio of = (Tearing strength of punched plate)/ (tearing strength of the solid plate)
Answer is:
D/T
Explanation:
Module Module is the length of pitch circle diameter per tooth. It is denoted by 'm'.
where m= d/T
d=Pitch circle diameter
T = Total number of teeths in gear
Answer is:
bending, torsion and thrust load
Explanation:
In lathe, the main spindle shaft holding the chuck is subjected to bending, torsion and thrust load.
