When gases entrapped on the surface of the casting due to solidifying metal, a rounded or oval cavity is formed called as blowholes. These defects are normally present in the cope part of the mold.
11) Blow holes are casting defects
Answer is:
Which takes the form of internal voids of surface depression due to excessive gaseous material not able to escape
Explanation:
Related KPCL JE Mechanical Question Paper - 2018 with Answer Key
Answer is:
Ductile material
Explanation:
Discontinuous chips Discontinuous chips are usually formed during machining of brittle materials like cast iron. The low cutting speed and small rake angle of the tool are responsible for the formation of discontinuous chips.
Continuous chips Continuous chips are produced during machining of ductile materials like mild steel. The high cutting speed and large rake angle of the tool will result in the formation of continuous chips. These chips are in the form of long coils having the same thickness throughout.
Continuous chips with built up edge Continuous chips with built up edge are also produced during machining of ductile materials. The low cutting speed and small rake angle of the tool will result in the formation of continuous chips with built up edge. These chips are also formed when the cutting edge of the tool is dull.
Answer is:
In between boiler and generator
Explanation:
A thermal power station is a power station in which heat energy is converted to electricity. Typically, fuel is used to boil water in a large pressure vessel to produce high-pressure steam, which drives a steam turbine connected to an electrical generator. In thermal power plant, turbine is placed in between boiler and generator.
