Loosen both screws and push the body to the amount of offset

Loosen both the screws and push the base to the amount of offset

Loosen the screws opposite to the direction of movement and tighten the other screw

Loosen the screw on the direction of movement and tighten the other screw

trued at the chuck and the work is stationary

trued at the tailstock end when the work is running at slow rpm

trued at both ends and work is stationary

trued at both ends when the work is running at slow rpm

The tool material is soft

The tool overhanging is more than required

The carriage is not locked to the bed

The automatic feed is not used

length of taper is 80 mm

big diameter of taper is 80 mm

small diameter of taper is 80 mm

diameter up to which the mating parts match

The work axis is kept out of alignment with the lathe axis and the tool movement is parallel to lathe axis

The work axis is kept in line with the lathe axis and the tool is made to move at an angle to lathe axis

The live and dead centres are moved in opposite directions to keep the work axis out of alignment with the lathe axis

The lathe axis is kept out of alignment with the work axis and the tool is made to move at an angle to the lathe axis