It is impossible to make anything to an exact size, therefore, it is essential to allow a definite tolerance or permissible variation on every specified dimension. Hence Tolerance is given to the part size to produce the parts, within the required permissible size error.
14) Tolerance is given to the part size to
Answer is:
Produce the parts within the required permissible size error
Explanation:
Related Limits and Fits MCQ - Machinist(Set-1) with Answers
Answer is:
IT01, IT0, IT1 to 16
Explanation:
As per BIS system of Limits and fits, there are 18 grades of tolerances represented by number symbols from IT01, IT0, IT1 to 16.
Answer is:
Lower deviation is -0.1 mm
Explanation:
The size of a component is given as 24 -0.1. In this -0.1 indicates Lower deviation which is -0.1 mm
Answer is:
may be easily replaced without rejection the assembly
Explanation:
In the assemblies obtained by using the system of Limits and fits, the damaged parts may be easily replaced without rejection the assembly.
Answer is:
0 to 500 mm
Explanation:
In the BIS system of limits and fits the standard range of sizes 'covered' are 0 to 500 mm.