75) Which one of the following is NOT a part of the taper turning attachment ?

Guide block

Sliding block

Guide bar

Carrier

Answer is:

Carrier

Lathe MCQ - Machinist(Set-1) with Answers

For more MCQ's Click Here

Related Lathe MCQ - Machinist(Set-1) with Answers

76) Which among of the following methods can be used for cutting long and narrow external taper threads ?

Tailstock offset method

Taper turning attachment method

Compound rest method

Either 'A' or 'B'

Answer is:

Either 'A' or 'B'

77) When using a yoke type taper turning attachment, the depth of cut is given by

cross slide

compound slide

tailstock

adjusting the tool

Answer is:

compound slide

78) Which one of the following methods is used to press the mandrel squarely to the workpiece ?

By hammering

By arbor press

By tailstock

By vice

Answer is:

By arbor press

79) Which among the following is the cause for incorrect pitch of thread during thread cutting with single point tool ?

Incorrect selection of change gears

Lead screw worn out

Half nut worn out

Any of the above

Answer is:

Any of the above

Explanation:

Incorrect pitch of thread during thread cutting with single point tool due to
Incorrect selection of change gears
Lead screw worn out
Half nut worn out

Which among the following is the cause for incorrect pitch of thread during thread cutting with single point tool ?

Lathe MCQ - Machinist(Set-1) with Answers

For more MCQ's Click Here