www.ThinkITI.com

Home
MCQ
Search
Free Apps
Important
Study Groups
Contact Us
Policy

Home
MCQ
Objective Questions
ITI
Fitter
Fitter Set-1
Fasteners
28

Fasteners MCQ with Answers

28) Which one of the following reasons is responsible for splitting of the metal in the riveted joint ?

Pitch of the rivets is too large

Holes of the rivets are drilled too near from the edge of the plate

Pitch of the rivets is too small

Holes for the rivets are drilled too far from the edge of the plate

Answer is:

Holes of the rivets are drilled too near from the edge of the plate

Fasteners MCQ with Answers

For more MCQ's Click Here

29) Which one of the following is responsible for tearing of plates in a riveted joint ?

Diameter of rivet is too large

Holes for rivets are drilled too close

Holes for rivets are drilled too near to the edge of the plates

Holes for rivets are drilled too far from the cutting edge of the plates

Answer is:

Holes for rivets are drilled too close

30) A split pin is used for locking purposes in

Castle nut

Square nut

Check nut

Flanged nut

Answer is:

Castle nut

A split pin is used for locking purposes in

31) Which one of the following thread forms is mostly found on threaded shaft of lifting equipment for carrying loads ?

'V' thread

Square thread

Saw tooth thread

Knuckle thread

Answer is:

Square thread

Explanation:

Square threads are used for transmitting motion or power. Eg. screw jack, vice handles, cross-slide and compound slide, activating screwed shafts.

Which one of the following thread forms is mostly found on threaded shaft of lifting equipment for carrying loads ?

32) A gap between two sheets was noticed after riveting. This defect is caused due to

Short rivet length

Oversized drilled hole

improper use of rivet set

The rivet being too long

Answer is:

improper use of rivet set

Fasteners MCQ with Answers

For more MCQ's Click Here

28) Which one of the following reasons is responsible for splitting of the metal in the riveted joint ?

Holes of the rivets are drilled too near from the edge of the plate

Fasteners MCQ with Answers

Related Fasteners MCQ with Answers

29) Which one of the following is responsible for tearing of plates in a riveted joint ?

Holes for rivets are drilled too close

30) A split pin is used for locking purposes in

Castle nut

31) Which one of the following thread forms is mostly found on threaded shaft of lifting equipment for carrying loads ?

Square thread

32) A gap between two sheets was noticed after riveting. This defect is caused due to

improper use of rivet set

Fasteners MCQ with Answers