1)Drawing Down: Drawing down is a process of elongate the length and reduce the cross section area of work piece. Simply in this operation, the length of work piece increases and the cross section area decreases. In this process, a compressive force is applied at perpendicular direction of its length axis. If a tensile force is applied to change its length at parallel to its length axis, this process is known as wire drawing.
2) Upsetting: Upsetting is just opposite operation to drawing down. In this operation, the length of work piece decreases and its cross section area increases. In this process, a compressive force is applied at parallel direction to its length axis.
24) The process of increasing the cross-section of a bar at the expense of its length is called
Answer is:
upsetting
Explanation:
Related Workshop Technology MCQ with Answers
Answer is:
drawing down
Explanation:
1)Drawing Down: Drawing down is a process of elongate the length and reduce the cross section area of work piece. Simply in this operation, the length of work piece increases and the cross section area decreases. In this process, a compressive force is applied at perpendicular direction of its length axis. If a tensile force is applied to change its length at parallel to its length axis, this process is known as wire drawing.
2) Upsetting: Upsetting is just opposite operation to drawing down. In this operation, the length of work piece decreases and its cross section area increases. In this process, a compressive force is applied at parallel direction to its length axis.
Answer is:
tube drawing
Explanation:
A moving mandrel is used in Tube drawing.
Answer is:
annealing is needed between stages
Explanation:
Tandem drawing is the drawing force of the process through two dies in tandem was evaluated by being compared with the drawing force of a conventional drawing process
Tandem drawing of wires and tubes is necessary because Annealing is needed between stages
Answer is: